SILCA SYNERG-E WET LUBE: The Ideal Lubricant for E-Bikes. This ultimate wear-reducing lubricant for e-bikes is based on the award-winning Synergetic lubricant. It's the first and only wet lube to record a 0.0% wear block in Zero Friction Cycling lab testing. Synerg-E combines SILCA's patent-pending Tungsten Tribofilm Technology into a higher viscosity lubricant, perfect for the high torque in e-bike drivetrains. E-bike chains face over 2X the internal pressures of traditional bike chains and can wear out costly drivetrain parts like chains, chainrings, and cassettes at more than double the rate. By increasing viscosity and adding Calcium Sulfonate, Synerg-E sacrifices about 1 watt of pure efficiency compared to Synergetic but nearly doubles the oil film strength, ensuring the lowest chain and drivetrain wear rates among all available lubricants. Like all SILCA lubricants, Synerg-E uses only top-quality, eco-friendly pure synthetic base oils with EPA and Bureau of Land Management - approved additives. It contains no PFAS or other fluorinated chemicals. Specifications: Specifically formulated for e-bikes, has the highest film strength of any bicycle lubricant, offers maximum corrosion protection, comes in a 2oz / 59ml squeeze bottle with a precision applicator tip, provides over 15,000 kms of lubrication per bottle, is an ultra - high - wearing, ultra - quiet, ultra - waterproof wet lube, and is eco - friendly (PFAS & VOC free). Instructions: Synerg - E works best on a clean and dry chain, but it's not essential. It can displace factory grease on common chain brands if dripped on a new chain. Make sure the chain is free of dirt and contaminants before applying. For initial application on a clean/dry chain: Apply 1 drop of Synerg - E to each set of gaps on each roller (2 drops per roller). Cycle the chain backwards 10 - 12 times to let the lubricant penetrate fully. Wipe the outside of the chain and chainrings as dry as you can with a microfiber cloth. Re - apply 1 drop per roller every 500 - 750 kms or after every wet/rainy ride.

Hey there! Using Silca Synerg - e wet lube on your e - bike is a breeze. First, while it works best on a clean and dry chain, you don't have to stress too much about it. If you've got a new chain, just drip the lube on top, and it'll gradually get rid of the factory grease. Before you start, make sure to clean off any dirt or gunk from the chain. For the first time you use it on a clean and dry chain, put 1 drop of the lube into each set of gaps on every roller, that's 2 drops per roller. Then, turn the chain backwards about 10 - 12 times so the lube can soak in well. After that, take a microfiber cloth and wipe the outside of the chain and chainrings as dry as you can. As for when to re - apply, add 1 drop per roller every 500 - 750 kms or after you've ridden in the wet or rain. Keep your e - bike well - lubricated, and it'll run smoothly for a long time!