The Grin All - Axle Cycle Analyst Based Conversion Kit comes with a Baserunner L10 Controller or Phaserunner Controller, along with PAS/Torque Sensor Options. It supports both Quick Release and Thru Axle Suspension Forks. These CA3 kits use a V3 Cycle Analyst as both the display and the main control system. It can handle and adjust responses to throttles, torque sensors, PAS sensors, and e - brake cutoffs. This is the most versatile system around, perfect for tech - savvy e - bike enthusiasts.

To use this conversion kit, first, install the chosen controller (either Baserunner L10 or Phaserunner) according to the provided instructions. Then, connect the PAS or torque sensor as needed. The V3 Cycle Analyst display should be easily visible on your bike. When using the bike, remember that the system will respond to your throttle, torque, and PAS sensors. Always check the e - brake cutoff to ensure safety. For maintenance, keep the components clean and dry. Periodically check the connections to make sure they are tight. If you notice any unusual behavior, refer to the troubleshooting section in the manual or contact customer support.