The brand - new EBMX large 3.5 - inch TFT display is a perfect match for the X - 9000 Motor Controller, replacing the smaller SW102 display. It works with any X9000 V2 on all motor and battery combinations. Thanks to canbus communications, it operates much faster and more accurately than the SW102's UART communications. The base kit comes with CNC mounts for MTB and Moto Bars (31.8 and 28.6), a new canbus 2 - 1 cable. It requires no setup, just install (830 and up firmware required). With an IP67 rating, it's durable. A new mode button is included, with a 350mm cable from the display to the button and a 250mm cable from the display to the canbus connector. It features an all - new EBMX UI that shows ride data. An optional case is available for purchase. Note that while the display is CAN Bus controlled directly from the X9000 and can be installed in an Ultrabee, it's not directly plug - and - play for Ultrabee R with indicators or headlights. Using it on an Ultra Bee R may prevent you from seeing indicator status, which we don't recommend for safety reasons as of September 2024.

Using the EBMX BC351 display is easy. First, make sure your X - 9000 Motor Controller has firmware 830 or higher. Then, install the CNC mounts on your MTB or Moto Bars (31.8 and 28.6). Connect the canbus 2 - 1 cable to the display and the controller. Attach the mode button using the 350mm cable and connect the display to the canbus connector with the 250mm cable. You don't need to do any setup, just start using it. When using, be aware that if you install it on an Ultrabee R, you won't be able to see the indicator status clearly, so it's not recommended for safety. To maintain the display, since it has an IP67 rating, it can withstand some water and dust. But still, try to keep it clean and avoid scratching the 3.5 - inch TFT screen. If you want an extra layer of protection, you can buy the optional case.